Painter's Touch 2X Ultra Cover Spray Paint, 12oz Rust-Oleum® Painter’s Touch® 2X Ultra Cover contains technology that provides twice the coverage on wood, metal, most plastic, wicker and more when compared to other matching colors of Rust-Oleum general purpose paints: Painter’s Touch, SPRAY N GO, Quick Color and Touch ‘n tone. It covers surfaces with less spray passes, allowing projects to be completed faster and easier. Any angle spray feature allows you to spray in any direction, even upside down. Fast Drying. PRODUCT FEATURES * Premium general purpose spray paint * Ultimate coverage * Apply to a variety of surfaces - wood, plastic, metal and more * Any-angle spray system allows you to spray at any angle for those hard to reach areas * Comfort spray tips helps eliminate finger fatigue for those larger projects * Fast drying PRODUCT APPLICATION Painting Conditions: Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy, dusty conditions. Cover surrounding area to protect from spray mist. Preparation: Remove loose paint and rust with wire brush or sandpaper. Lightly sand glossy surfaces. Clean with soap and water, rinse and let dry. WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. Priming: Use of Painter’s Touch 2X Ultra Cover® primer provides superior adhesion and hiding and is especially recommended for bare wood and metal. Painting: Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Dry & Recoat: Times based on 70°F – 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 20 minutes, to handle in 1 hour and fully dry in 24 hours. Apply a second coat or Clear coat within 1 hour or after 48 hours. Apply clear in 2-3 light coats a few minutes apart. NOTE: On plastic maximum paint adhesion and durability is achieved in 5-7 days. Clean-up: Wipe off tip before storing. Clean up wet paint with Xylol or mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor. Clogging: If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick pin or other object into the stem.