Maximum 4 Gallons per Check Out
DESCRIPTION: Nation® Fast Dry Enamel is an alkyd type paint that provides durability and fast drying characteristics at an affordable price. It is intended to beautify and protect wood and metal surfaces.
PRINCIPAL USES: For exterior and interior wood and metal surfaces.
PRACTICAL COVERAGE: 20 - 25 sq.m./4 liters/coat
DRY FILM THICKNESS: 1.5 mils/coat
OVERCOATING INTERVAL: Allow eight (8) hours before recoating
THINNING: Use Columbus Paint Thinner #43 as necessary
APPLICATION: paint brush or roller
SURFACE PREPARATION:
Wood - Surface to be painted should be clean and dry, free from dust, dirt and other foreign matter. Hammer all nails deep enough to apply putty. Sand rough wood until smooth, then dust off before painting.
If repainting, first remove all blistering, peeling and scaling paint then prime with NS Flatwall Enamel #800 before recoating.
Metal - Wipe the surface with rag soaked in paint thinner to remove dust, dirt, grease, oil, wax and other foreign matter. For new G.I. sheets, etch the surface by applying 10% BOYSEN® Metal Etching Solution #71 (dilute 1 part of B-71 to 9 parts water).
If repainting, wire brush or scrape rusted metals and apply BOYSEN® Metal Etching Solution #71 to remove all rust. Let it stay for 10-15 minutes. Be sure to wash off surface thoroughly with water, letting it dry before applying paint. Prime immediately after drying.
PAINTING SCHEDULE:
WOOD
1st Coat NS Flatwall Enamel #800
Putty BOYSEN® Plasolux Glazing Putty #311
2nd & 3rd Coat NS Fast Dry Enamel (any desired color)
METAL
1st Coat NS Red Oxide #610
2nd & 3rd Coat NS Fast Dry Enamel (any desired color)