Protect your screen from scratches For Honda Click V3 Screen protector available in different colors. Please choose correct variation. Panel protector - 3D Carbon Panel and screen protector Panel Gauge Film Protector for Motorcycle with 3d carbon panel protector Added protection to your panel Scratch Proof Panel Waterproof High Quality Adhesive Low Price MACHINE CUT Satisfaction Guaranteed Installation Procedure 1. Clean your motorcycle's panel gauge 2. Make sure there is no dust or dirt on your panel before you install the sticker film 3. The clear sticker film has three layers. the front cover, the back cover, and the one in the middle is the panel protector itself. 4. The front cover is much softer than the back cover. Back cover protects the sticky side so make sure that you put the sticker guide on the back cover (the harder sheet) 5. you can do the installation in two ways: A. Direct installation - slightly peel off the back cover from the corner and then attach directly to the gauge. Make sure its perfectly placed before completely peeling off the full back cover of the film. After you place the film on the panel, get an atm card and cover it with fabric, then use it to rub the surface of the panel to prevent bubbles. B. Water process - remove the back cover (sticky side) entirely from the film, then spray water all over the sticky surface of the film, as well as on your motorcycle's panel gauge. Then carefully attach the film on the gauge. after its perfectly placed, you can rub using atm covered with fabric to prevent bubbles.